To demonstrate the simplicity of installing a Bio-Pure system, a step by step guide is featured below.The guide shows the 8 basic steps required in the installation of the system.
If you decide to purchase a Bio-Pure, you will receive the detailed written manual for further instruction.
1) The Bio-Pure should be at least 7m from2) Excavate a hole 1.7m deep by 1.85m
a dwelling and not too close to trees,wide using a digger. Ensure the hole is
because of the roots.narrower at the bottom.
3) Lower the Bio-Pure into the ground 4) Dig the appropriate depth hole for
using the digger. Install anchoring kit now, the inlet invert and make the connection.
if required.Ensure the unit is level.
5) Backfill the unit to approx. 700mm,6) Make the outlet connection (via sample
using pea gravel. Partly fill the unitchamber if necessary). Complete backfill
with water.and filling with water.
7) Make the electrical connection from an RCD 8)Sit back and relax!
and use a double outside socket.
*This installation guide is the property of bio-pure.com
Kingsnordley Farm, Kingsnordley, Bridgnorth, 